Asko FN31831i - Инструкция по эксплуатации - Страница 12

EN 12

INSTALLATION AND CONNECTION

•  The appliance must be placed at a distance of about 5 cm from the wall, back and sides 

of a cupboard. A kitchen cupboard above the refrigerator must have a gap of at least 5 cm 

between the back of the cupboard and the wall. This is needed to make sure that there is 

sufficient cooling air for the condenser.

•  The plug of the installed appliance must remain accessible!

Place the appliance in a room with a sufficient volume of air. The room must have a
volume of at least 1 m

3

 of air for every 8 grams of refrigerant. The quantity of 

refrigerant is shown on the type plate on the inside of the appliance.

•  The kitchen unit in which the appliance is to be built in must have an opening of at least 

200 cm

2

 in its base to allow sufficient air to circulate.

•  The appliance’s air outlet is at the top. Make sure that the outlet is not blocked. Blocking the 

outlet can result in damage to the appliance.

Warning:

An anti-condensation accessory must be installed before built-in appliances are 
installed next to each other in a cupboard or surround. 

For safety reasons, this must 

be installed by a recognized installer!

Connecting the appliance

•  Connect the appliance to the power supply with a plug. The socket must be earthed. The 

nominal voltage and frequency required for the appliance are shown on the appliance’s type 

plate/label with basic information.

•  The appliance must be connected to the mains and earthed in accordance with the 

prevailing standards and regulations. The appliance can withstand small variations in the 

mains voltage to a maximum of plus or minus 6%.

When you are not going to use the appliance for a longer period then switch it off with
the appropriate key and disconnect it from the mains. Empty, defrost and clean the
appliance, and leave the door ajar.