Bosch KGN36VL326 - Инструкция по эксплуатации - Страница 22

en

22

Fault

Possible cause

Remedial action

Controls have reduced 

luminosity.

When the appliance is not 

used for some time, 

the display on the fascia 

switches to energy saving 

mode.

As soon as the appliance is again used, e.g. 

the door is opened, the display switches back 

to normal illumination.

Displays do not illuminate.

Power failure; the fuse has 

been switched off; the mains 

plug has not been inserted 

properly.

Connect mains plug. Check whether the power 

is on, check the fuses.

Appliance is not cooling, 

temperature display and light 

are lit.

Showroom mode is 

switched on.

Hold down temperature selection button 

fig. 

"

/2 for 10 seconds until 

an acknowledgement signal sounds.
After a short time check whether your 

appliance is cooling.

Freezer compartment door 

was open for a long time; 

temperature is no longer 

reached.

The evaporator (refrigeration 

generator) in the 

NoFrost system is covered 

in thick ice and can no 

longer be defrosted fully 

automatically.

To defrost the evaporator, remove the frozen 

food with the compartments, insulate well 

and store in a cool location.
Switch off the appliance and move it away 

from the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins 

to run into the evaporation pan, at the rear of 

the appliance.
To prevent the evaporation pan 

from overflowing in this case, mop up the 

condensation with a sponge.
The evaporator is defrosted when the water 

stops running into the evaporation pan. Clean 

the interior. Switch the appliance 

back on again.

Condensation accumulates 

on the surface of the 

appliance and on the shelves 

inside.

The effect is reinforced if 

ambient temperatures are 

warm and humid.

Wipe away the water with a soft, dry cloth.

■

Open the appliance as briefly as possible

■

Make sure that the appliance is always 

closed properly.