Генераторы AL-KO 6500 D-C - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
GB
Original instructions for use
20
Petrol Generator 2500-C / 3500-C / 6500-C
Start-up
Important!
Generator must be safely earthed
The camera symbol on the following pages refers
WRWKH¿JXUHVRQSDJHV±
Earthing the machine
Important - Electric shock!
Do not use a bare wire for earthing.
Important!
Generator must be safely earthed
Use an earthing wire with a cross-section of at
least 2.5 mm
2
for earthing
Connecting the earthing wire
(
1)
Press the end of the earthing wire under the nut of the
earthing terminal.(
1/1)
1. Secure the earthing wire by tightening the nut
2. Connect the other end of the earthing wire to an
earthing spike (e.g. metal rod)
3. Put the earthing spike securely into the soil
Connecting the starter battery
(AL-KO 6500-C only)
(
6)
1. Connect the red battery cable with the positive
terminal of the starter battery. Tighten using screw
and nut
2. Connect the green battery cable with the negative
terminal of the starter battery. Tighten using screw
and nut
3. Slide rubber grommets over the starter battery
terminals after tightening
Avoid contact between the positive and negative
terminal of the battery, as this could damage the
battery
Opening the petrol cock
(
6)
1.
2SHQWKHSHWUROFRFNDQGKDYHSHWUROÀRZLQWRWKH
carburettor
Choke
(
7)
1. Close the choke lever during a cold start.
2. When the machine is running at operating tempera-
ture, put the choke lever in the half-open position.
If the machine still does not start after two
attempts, open the choke lever fully.
Starting the engine
Important – Danger of poisoning!
Never run the engine in enclosed spaces.
Important – Danger of injury!
Important – Danger of kickback!
Cable starter can return faster to the engine
than the cable can be released.
Cable starter
1. Set the ignition circuit breaker to "ON" (
8
)
2. Pull out the cable starter briskly, and then allow it to
wind back in slowly (
9
)
If the machine still does not start after the second
attempt, follow the instructions for the choke
Electrical starting (AL-KO 6500-C only)
1. Insert the key into the ignition
2. Turn the key in the ignition clockwise into the
"START" position (
10
)
3. As soon as the engine is running, release the
ignition (returns into the "ON" position).
The interval between starting attempts should be
10 seconds to avoid too fast discharging of the
starter battery
If the machine still does not start after the second
attempt, follow the instructions for the choke
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
