Texas XTB 50 TR/W 90066048 - Инструкция по эксплуатации - Страница 25

24 

Oil change 

 
The oil must be changed after the first 5 hours of use. After that the oil must be changed at 
least once a year. 
 

1.  Let the engine run for 5 minutes to warm up the oil. This makes it run easier and 

make the oil change more complete. 

2.  Turn off the engine after 5 minutes. Take off the spark plug cap. Unscrew the 

cork for the drain plug. Theo oil now runs out of the engine. Keep a suitable 
container ready to collect the oil.  

NOTE 

that the engine may only be tilted backward at an angle of max 45 

degrees. 
Refit the drain plug and pour fresh oil into the engine. 

3.  This is done by removing the oil stick and filling with correct amount of oil. 
4.  Mount the spark plug cap. 

Alternatively use an oil changing kit: 

1.  Suck the oil up through the oil filler hole using the 

syringe. (See the section Identification of parts, Pos 
C.) Use the hose as an extension piece to reach the 
bottom of the engine. Transfer the used oil to the 
accompanying container.  
 

2.  Fill the engine with new oil, type SAE30.  

Check the oil level using the dipstick on the oil bung 

Remember to dispose of the used oil so that it is not harmful to nature.  
Use your local recycling station.

Oil and oil changing kit is not included.

 
 
Spark plug 

1.  Remove the spark plug cap.  
2.  Brush off dirt from the top of spark plug. 
3.  Use a spark plug wrench to loosen the spark plug. 
4.  Check that the isolation is intact.  
5.  Clean the spark plug with a steel brush. 
6.  Measure the electrode distance. Be careful not to damage the electrode. 
7.  The distance should be: 0,7 - 0,8 mm 
8.  If the spark plug is undamaged refit. Otherwise replace it. 
9.  Mount the spark plug cap.