Ryobi 4-in-1 RLM53175S 5133002555 - Инструкция по эксплуатации - Страница 12

English

10

REPLACING THE WHEELS

See figure 17.

 WARNING

Only use replacement wheels approved by the 
manufacturer of the product. Using wheels that are 
not approved by the manufacturer  of the product  is 
hazardous and could result  in serious personal injury.

1.  Stop the engine and disconnect the spark plug wire. 

Allow blade to come to a complete stop.

2.  Remove the hub cap.
3.  Remove the nut from the wheel axle, then remove the 

wheel. 

4.  Replace with new wheel and reinstall nut to secure.

STORING THE PRODUCT

When storing the product for 30 days or more:

■

If using a fuel stabilizer, follow the stabilizer 
manufacturer’s directions to add stabilizer to petrol in 
the fuel tank. Run the engine at least 10 minutes after 
adding stabilizer to allow the stabilizer to reach the 
carburetor.

 WARNING

Do not store the product with petrol in the tank inside a 
building where fumes may reach an open flame or spark.

■

If not using a fuel stabilizer, allow the engine to run until 
the product is completely out of petrol.

■

Once the engine has stopped, allow the blade to come 
to a complete stop and disconnect the spark plug wire.

■

Turn the fuel valve to the closed position.

■

Turn the product on its side (with carburetor facing up) 
and clean grass clippings that have accumulated on the 
underside of the mower deck.

■

Clean the underside of the mower deck.

■

Wipe the product clean with a dry cloth.

■

Check all nuts, bolts, knobs, screws, fasteners, etc., for 
tightness.

■

Inspect moving parts for damage, breakage, and wear. 
Have repairs made on any damaged or missing parts.

■

Store the product in a well-ventilated area that is clean, 
dry, and out of the reach of children. 

■

Do not store near corrosive materials, such as fertilizer 
or rock salt.

To lower the handle before storing:

See figure 18.

■

Remove starter rope from the guide and allow it to 
retract into the engine.

■

Remove the grass catcher.

■

Release the upper quick release fasteners of the upper 
handle and fold the upper handle down.

■

Release the lower quick-release fastener.

■

Fold the lower handle forward past the edges of the 
handle mounting brackets and make sure that the 
bracket supports the handle; otherwise, the air filter 
may be damaged.

■

Close the lower quick release fasteners and let the 
bracket support the handle, making sure not to bend or 
kink the control cables.

TRANSPORTATION

■

Stop the product, disconnect the spark plug wire, and 
wait until the blade comes to a complete stop. Allow  the 
product to cool down.

■

Empty the fuel tank by running the engine until it stops. 
Empty oil by following the instruction for changing oil.

■

Secure the product against movement or falling to 
prevent injury to persons or damage to the product.