Husqvarna LC347VXi 9678623-01 - Инструкция по эксплуатации - Страница 20

WARNING: Use heavy duty gloves. The

blade is very sharp and cuts can easily

occur.

10. Start the product to do a test of the blade. If the

blade is not correctly attached, there is vibration in

the product or the cutting result is unsatisfactory.

Troubleshooting

Battery

LED on the battery

Possible faults

Possible procedure

The green LED is flash-

ing

The battery voltage is low

Charge the battery. See 

To charge the battery on

page 17.

The error LED flashes

The battery is weak

Charge the battery. See 

Battery on page 20.

The temperature in the work environ-

ment is too high or too low

Use the battery in temperatures between -10°C

and 40°C.

Overvoltage

Check that the mains voltage is the same as on

the rating plate on the product.

Remove the battery from the battery charger. Wait

5 seconds and try again to charge the battery. If

the problem continues, speak to an authorised

service agent.

The error LED is on

Cell difference too much (1V)

Speak to an approved service agent.

Battery charger

LED on the battery

charger

Possible faults

Possible procedure

The error LED flash-

es

The temperature in the work en-

vironment is too high or too low

Use the battery charger in temperatures between 5°C

and 40°C.

The error LED is on

Speak to an approved service agent

Control panel

Keypad

Error code (Num-

ber of flashes)

Possible faults

Possible action

Error LED flashes

3

The motor is overloaded

Increase the cutting height. Refer to 

To

set the cutting height on page 16.

5

The motor speed drops too

much, and the motor stops

10

The motor control is too hot

Stop the motor and wait until it has be-

come cool

2

The blade is blocked

To prevent accidental start turn the safe-

ty key to 0, remove the battery and wait

a minimum 5 seconds. Make sure that

the blade can rotate freely. If the prob-

lem continues, speak to an authorised

service agent

9

Battery error or no signal from

battery

Put the battery in the product correctly

and examine the battery connector. If the

error LED on the battery flashes. Refer

to 

Battery on page 17.

20

890 - 002 - 21.12.2018