Газонокосилки Husqvarna LB 553S e. Профи 9678625-01 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
Introduction
WARNING:
Before you do maintenance,
you must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 9.
Maintenance
Daily
Weekly
Monthly
Do a general inspection
X
Examine the oil level
X
Clean the product
X
Clean the air filter
X
Examine the cutting equipment
X
Examine the cutting cover *
X
Examine the belt guard *
X
Examine the engine brake handle *
X
Examine the muffler *
X
Examine the vibration damping system *
X
Examine the spark plug
X
Examine the drive belt for damages
X
Clean the gear housing
X
Replace the oil (the first time after 5 h of use, then after each 25 h of
use and yearly.)
X
Replace the air filter
X
Examine the fuel system
X
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
To clean the product externally
• Use a brush to remove leaves, grass and dirt.
• Make sure that the air intake on the top of the engine
is not blocked.
12
895 - 003 - 16.10.2018
