Bosch ROTAK 37 0.600.8A4.100 - Инструкция по эксплуатации - Страница 13

 English | 

13

Bosch Power Tools

F 016 L81 153 | (1.7.14)

Electrical Safety



Warning! Switch off, remove plug 
from mains before adjusting, 
cleaning or if cable is cut, dam-
aged or entangled.



The blades continue to rotate for a 
few seconds after the machine is 
switched off.



Caution  –  do not touch the rotat-
ing blade.

Your machine is double insulated for 
safety and requires no earth connec-
tion. The operating voltage is 230 V AC, 
50 Hz (for non-EU countries 220 V, 
240 V as applicable). Only use ap-
proved extension cables. Contact your 
Bosch Service Centre for details.
Extension cords/leads should only be 
used if they comply with H05VV-F, 
H05RN-F types or IEC type design 
(60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable 
when operating your product, only the 
following cable dimensions should be 
used:
– 1.0 mm

2

: max. length 40 m

– 1.5 mm

2

: max. length 60 m

– 2.5 mm

2

: max. length 100 m

Note: If an extension cable is used it 
must be earthed and connected 
through the plug to the earth cable of 
your supply network in accordance 
with prescribed safety regulations.
If in doubt contact a qualified electrician 
or the nearest Bosch Service Centre.



WARNING! Inadequate extension 
cables can be dangerous. Exten-
sion cable, plug and socket must 
be of watertight construction and 
intended for outdoor use.

Cable connections should be kept dry 
and off the ground.
It is recommended for increased elec-
trical safety to use a Residual Current 
Device (RCD) with a tripping current of 
not more than 30 mA. Always check 
your RCD every time you use it.
For products 

not sold in GB

:

WARNING:

 For your safety, it is re-

quired that the plug attached to the ma-
chine is connected with the extension 
cord. The coupling of the extension 
cord must be protected against splash 
water, be made of rubber or coated 
with rubber. The extension cord must 
be used with a cable strain relief.
The connection lead must be inspected 
for signs of damage at regular intervals 
and may only be used if in perfect con-
dition.
If the supply cord is damaged, it must 
be replaced by a Bosch Service Centre.

Products sold in GB only

: Your prod-

uct is fitted with a BS 1363/A approved 
electric plug with internal fuse (ASTA 
approved to BS 1362).
If the plug is not suitable for your socket 
outlets, it should be cut off and an ap-
propriate plug fitted in its place by an 
authorised customer service agent. 
The replacement plug should have the 
same fuse rating as the original plug.
The severed plug must be disposed of 
to avoid a possible shock hazard and 
should never be inserted into a mains 
socket elsewhere.

Products sold in AUS and NZ only

: 

Use a residual current device (RCD) 
with a rated residual current of 30 mA 
or less.

OBJ_BUCH-1919-004.book  Page 13  Tuesday, July 1, 2014  9:57 AM