Газонокосилки Bosch ARM 3200 0.600.8A6.008 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
12
| English
F 016 L81 177 | (24.9.14)
Bosch Power Tools
Always wear gardening gloves when
handling or working near the sharp
blades.
Electrical Safety
Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is cut, damaged
or entangled.
The blades continue to rotate for a
few seconds after the machine is
switched off.
Caution – do not touch the rotating
blade.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
Extension cords/leads should only be
used if they comply with H05VV-F,
H05RN-F types or IEC type design
(60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
– 1.0 mm
2
: max. length 40 m
– 1.5 mm
2
: max. length 60 m
– 2.5 mm
2
: max. length 100 m
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
WARNING! Inadequate extension
cables can be dangerous. Exten-
sion cable, plug and socket must be
of watertight construction and in-
tended for outdoor use.
Cable connections should be kept dry
and off the ground.
It is recommended for increased elec-
trical safety to use a Residual Current
Device (RCD) with a tripping current of
not more than 30 mA. Always check
your RCD every time you use it.
The connection lead must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cord is damaged, it must
be replaced by a Bosch Service Centre.
For products
not sold in GB
:
WARNING:
For your safety, it is re-
quired that the plug attached to the ma-
chine is connected with the extension
cord. The coupling of the extension
cord must be protected against splash
water, be made of rubber or coated
with rubber. The extension cord must
be used with a cable strain relief.
Products sold in GB only
: Your prod-
uct is fitted with a BS 1363/A approved
electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket
outlets, it should be cut off and an ap-
propriate plug fitted in its place by an
authorised customer service agent.
The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of
to avoid a possible shock hazard and
should never be inserted into a mains
socket elsewhere.
OBJ_BUCH-2341-001.book Page 12 Wednesday, September 24, 2014 1:30 PM
