Sony DSC-WX150 - Инструкция по эксплуатации - Страница 6

GB

6

[

Note:

This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in 
a residential installation. This equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or 
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

The supplied interface cable must be used with the equipment in order to comply with the 
limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

[

Notice for the customers in the countries applying EU Directives

The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 
108-0075 Japan. The Authorized Representative for EMC and product safety is Sony 
Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any service or 
guarantee matters please refer to the addresses given in separate service or guarantee 
documents.

This product has been tested and found compliant with the limits set out in the EMC 
Directive for using connection cables shorter than 3 meters (9.8 feet).

[

Attention

The electromagnetic fields at the specific frequencies may influence the picture and sound 
of this unit.

[

Notice

If static electricity or electromagnetism causes data transfer to discontinue midway (fail), 
restart the application or disconnect and connect the communication cable (USB, etc.) 
again.

For Customers in Europe