Sony Cyber-shot DSC-RX10 - Инструкция по эксплуатации - Страница 14

DSC-RX10

4-477-083-

31

(1)

E:\-31_RU3\01GB\010GB1RU3.fm

master:Left

GB

14

• If the charge lamp on the camera flashes when the AC Adaptor is connected to the 

wall outlet (wall socket), this indicates that charging is temporarily stopped 
because the temperature is outside the recommended range. When the temperature 
gets back within the appropriate range, the charging resumes. We recommend 
charging the battery pack in an ambient temperature of between 10°C to 30°C 
(50ºF to 86ºF).

• The battery pack may not be effectively charged if the terminal section of the 

battery is dirty. In this case, wipe any dust off lightly using a soft cloth or a cotton 
swab to clean the terminal section of the battery.

• Connect the AC Adaptor (supplied) to the nearest wall outlet (wall socket). If 

malfunctions occur while using the AC Adaptor, disconnect the plug from the wall 
outlet (wall socket) immediately to disconnect from the power source.

• When charging is finished, disconnect the AC Adaptor from the wall outlet (wall 

socket).

• Be sure to use only genuine Sony brand battery packs, micro USB cable (supplied) 

and AC Adaptor (supplied).

• Power is not supplied during shooting/playback if the camera is connected to a 

wall outlet with the supplied AC adaptor. To supply power to the camera during 
shooting/playback, use the AC-PW20 (sold separately) AC adaptor.

x

Charging time (Full charge)

The charging time is approximately 310 min. using the AC Adaptor 
(supplied).

• The above charging time applies when charging a fully depleted battery pack at a 

temperature of 25°C (77°F). Charging may take longer depending on conditions of 
use and circumstances.

Notes

Notes

010GB1RU3.fm  Page 14  Monday, September 2, 2013  6:43 PM