Ecosoft FK1035CABECEMIXC - Инструкция по эксплуатации - Страница 19

19

INSTRUCTION MANUAL ECOSOFT

®

 MEDIA SYSTEMS

Make sure all external cables are routed through guides in control valve backplates, so the 
front panel can be put back on. Plug both power supplies in mains to power up the system.

8

.  Enter programming menu and setup both control valves for Duplex operation (see 

programming instructions in the next section).

9

.  Start  manual  regeneration  of  the  first  filter  by  holding  REGEN  button  for  5  seconds. 

Scroll regeneration to backwash if it isn’t the 1st step of the sequence. When the control 

valve starts the backwash, turn on mains water supply slightly at first. Air will be displaced 
from the system via drain line while the pressure tank is being filled with water. When the 
tank is full, water will start flowing down the drain line.

At this point, scroll through the rest of the regeneration sequence to end regeneration.

Then start manual regeneration of the second filter and scroll to backwash if it isn’t the 1st 

step. Wait until all air is displaced from the second tank. Then scroll through the rest of 
regeneration sequence to end regeneration.

Fully open mains water supply. Carefully inspect the system for leaks. Manually initiate two 

more complete regenerations of each filter, one after the other.