Brayer BR3040 - Инструкция по эксплуатации - Страница 6

6

EN

•  Examine the unit for damages, in case of damage 

do not plug it into the mains.

• 

Make sure that specified specifications of power 

supply voltage of the unit correspond to the 

specifications of your mains. When using the unit in 

the mains with 60 Hz frequency, the unit does not 

need any additional settings.

•  Wipe the unit with a clean, slightly damp cloth to 

remove dust, and then wipe it dry. 

•  Unwind the power cord to its full length while using 

the unit.

USING THE HAIRDRYER

•  Make sure that the operation mode switch (1) is set 

to the position «0».

•  Unwind the power cord completely.

•  Insert the power plug into the mains socket.

•  Use the switch (1) to set the required operation 

mode:

 -

«0» — the hairdryer is off;

 - «1» — warm air supply;

 - «2» — hot air supply.

• 

Note: 

— during the first operation a foreign smell 

and a small amount of smoke can appear from the 

heating element, this is normal and it is not covered 

by warranty.

• 

After finishing operation, switch the hairdryer off 

by setting the switch (1) to the position «0», and 

unplug it.

NOZZLE

•  Use the nozzle (3) when you need to focus the 

power of drying on a small area (for example, a curl 

or a wave) or when you want to straighten wavy hair.

•  Attach the nozzle (3) to the unit body. The nozzle (3) 

allows directing a narrow air flow of high intensity at 

a definite hair lock.

•  Insert the power plug into the mains socket. Use the 

switch (1) to set the necessary operation mode.

•  Periodically straighten the power cord if it gets 

twisted during operation.

OVERHEATING PROTECTION

•  The overheating protection system switches the 

hairdryer off if the outgoing air temperature is above 

the limit.

• 

If the hairdryer is switched off during operation, set 

the switch (1) to the position «0», unplug the unit 

and make sure that the air inlets and outlets are 

unblocked.

•  Let the unit cool down for 5-10 minutes and then 

switch it on again. Do not block the air inlets during 

operation of the hot air styler and

•  avoid getting of hair into the air inlet grid (4).

CLEANING AND  MAINTENANCE

•  The hairdryer is intended for household use only.

•  Set the switch (1) to the «0» position, disconnect the 

hairdryer from the mains and let it cool down.