Braun SES 9/890 - Инструкция по эксплуатации - Страница 12

12

Charging

Using the special cord set (7) connect
the appliance to an electrical outlet and
charge it for 2 hours.

Charging light (5)
Flashing green: charging
Green: fully charged
Yellow: 15 min charge left
Flashing yellow: 5 min charge left

•

Once fully charged, use the appliance 
cordless. Operation time is 50 minutes 
when it is used within 24 hours after 
charging. Recharge it when the yellow 
light comes on or when the motor has 
stopped completely. For best perfor-
mance, always use a fully charged 
appliance.

•

The best temperature range for charging, 
using and storing the appliance is 
between 15 °C and 35 °C. In case the 
temperature is far beyond this range, 
the charging time might be longer 
whereas the cordless operation time 
might be reduced.

•

At the end of its lifetime, the recharge-
able battery can be replaced at an 
authorized Braun Service Centre. 

How to operate the appliance

Switch on the appliance by pressing a 
lock key (4a) and turning the switch (4) 
clockwise to position «I» or «II». 
The SensoSmart

TM

 light (3) shines as long 

as the appliance is switched on, thus 
providing good visibility of fine hairs. 
When you apply too much pressure, the 
SensoSmart

TM

 light signals red.

To remove the epilation head, press the 
release button (6). To change caps (1a), 
(1b) or (8), press their lateral ribs and 
pull off.

A Epilation

Epilation tips

If you have not used an epilator before, or 
if you have not epilated for a longer period 
of time, it may take a short time for your 

skin to adapt to epilation. The discomfort 
experienced in the beginning will decrease 
considerably with repeated use as the 
skin adapts to the process. 

When epilating for the first time, it is advis-
able to epilate in the evening, so that any 
possible reddening can disappear over-
night. To relax the skin we recommend 
applying a moisture cream after epilation.
Epilation is easier and more comfortable 
when the hair is at the optimum length of 
2–5 mm. If hairs are longer, we recom-
mend that you shave first and epilate the 
shorter, re-growing hairs after 1 or 2 
weeks. Alternatively, you can trim the 
hairs to 5 mm length. 

Fine, regrowing hairs might not grow up 
to the skin surface. The regular use of 
massage sponges (e.g. after showering) 
or exfoliation peelings helps to prevent 
in-grown hair as the gentle scrubbing 
action removes the upper skin layer and 
fine hair can get through to the skin sur-
face.

Dry usage: Your skin must be dry and free 
from grease or cream.

Wet usage: The appliance can be used on 
wet skin, even under running water. Make 
sure that the skin is very moist in order to 
achieve optimum gliding conditions for 
the appliance. After each wet usage, clean 
the appliance under running water.

How to epilate 

Before use, always make sure that the 
epilation head (2) is clean and provided 
with a cap (1a or 1b).

1

  Select speed «I» for a gentle epilation 

and speed «II» for an efficient epilation. 

2

  Always stretch your skin when epilating. 

Make sure that the epilation area is in 
contact with your skin.

Guide the appliance in a slow, continuous 
movement without pressure against the 
hair growth, in the direction of the switch. 

91392809_SES_9890_9880_9870_9700_JUNO_S6-124.indd   12

91392809_SES_9890_9880_9870_9700_JUNO_S6-124.indd   12

30.05.17   08:26

30.05.17   08:26

CSS  APPROVED Effective Date  2Jun2017 GMT  - Printed 30Aug2017 Page 12 of 124