Makita KP0810C - Инструкция по эксплуатации - Страница 8

8 

locating lugs on the set plate. 

Fig.9 

7. 

The blade's lengthwise adjustment will need to be 
manually positioned so that the blade ends are 
clear and equidistant from the housing on one 
side and the metal bracket on the other. 

8. 

Tighten the three hex flange head bolts (with the 
socket wrench provided) and rotate the drum to 
check clearances between the blade ends and the 
tool body. 

9.  Check the three hex flange head bolts for final 

tightness. 

10.  Repeat procedures 1 - 9 for other blade. 

For the correct planer blade setting 

Your planing surface will end up rough and uneven, 
unless the blade is set properly and securely. The blade 
must be mounted so that the cutting edge is absolutely 
level, that is, parallel to the surface of the rear base. 
Refer to some examples below for proper and improper 
settings. 

(A)

(B)

(B)

(A)

(B)

(A)

(A) Front base (Movable shoe)
(B) Rear base (Stationary shoe)

Correct setting

Nicks in surface

Gouging at start

Gouging at end

Although this side view cannot 
show it, the edges of the blades 
run perfectly parallel to the rear 
base surface.

Cause: One or both blades fails to 

have edge parallel to rear 
base line.

Cause: One or both blade edges 

fails to protrude enough in 
relation to rear base line.

Cause: One or both blade edges 

protrudes too far in relation 
to rear base line.

EN0004-1 

Change of chip discharge direction 

Fig.10 

Chip discharge direction can be changed to the right or 
left. To change the direction, pull out the stopper while 
turning it slightly backward and fit in it in one of two 
openings on the opposite side of chip discharge so that 
the recessed part fits to protrusion. 

Fig.11 

Dust bag (accessory) 

Fig.12 

Attach the dust bag onto the chip discharge opening. 
The chip discharge opening is tapered. When attaching 
the dust bag, push it onto the chip discharge opening 
firmly as far as it will go to prevent it from coming off 
during operation. 
When the dust bag is about half full, remove the dust 
bag from the tool and pull the fastener out. Empty the 
dust bag of its contents, tapping it lightly so as to remove 
particles adhering to the insides which might hamper 
further collection. 

Fig.13 
NOTE: 

• 

If you connect a Makita vacuum cleaner to this tool, 
more efficient and cleaner operations can be 
performed. 

Connecting a vacuum cleaner 

Fig.14 

When you wish to perform clean planing operation, 
connect a Makita vacuum cleaner to your tool. Then 
connect a hose of the vacuum cleaner to the chip 
discharge opening as shown in the figures. 

Elbow (optional accessory) 

Fig.15 

Use of elbow allows change of chip discharge direction 
to perform cleaner work. 
Install the elbow (optional accessory) on the tool by just 
slipping on it. To remove it, just pull it out.