Makita KP0800 - Инструкция по эксплуатации - Страница 7

7 

Fig.9 

6. 

Set the drum cover over the adjusting plate/set 
plate and screw in the three hex flange head bolts 
so that a gap exists between the drum and the set 
plate to slide the mini planer blade into position. 
The blade will be positioned by the planer blade 
locating lugs on the set plate. 

7. 

The blade's lengthwise adjustment will need to be 
manually positioned so that the blade ends are 
clear and equidistant from the housing on one 
side and the metal bracket on the other. 

8. 

Tighten the three hex flange head bolts (with the 
socket wrench provided) and rotate the drum to 

check clearances between the blade ends and the 
tool body. 

9.  Check the three hex flange head bolts for final 

tightness. 

10.  Repeat procedures 1 - 9 for the other blade. 

For the correct planer blade setting 

Your planing surface will end up rough and uneven, 
unless the blade is set properly and securely. The blade 
must be mounted so that the cutting edge is absolutely 
level, that is, parallel to the surface of the rear base. 
Refer to some examples below for proper and improper 
settings. 

(A)

(B)

(B)

(A)

(B)

(A)

(A) Front base (Movable shoe)
(B) Rear base (Stationary shoe)

Correct setting

Nicks in surface

Gouging at start

Gouging at end

Although this side view cannot 
show it, the edges of the blades 
run perfectly parallel to the rear 
base surface.

Cause: One or both blades fails to 

have edge parallel to rear 
base line.

Cause: One or both blade edges 

fails to protrude enough in 
relation to rear base line.

Cause: One or both blade edges 

protrudes too far in relation 
to rear base line.

EN0004-1 

Dust bag (accessory) 

Fig.10 
For tool without nozzle 

Remove the chip cover and install the nozzle (optional 
accessory). Attach the dust bag onto the nozzle . The 
nozzle is tapered. When attaching the dust bag, push it 
onto the nozzle firmly as far as it will go to prevent it from 
coming off during operation. 

For tool with nozzle 

Attach the dust bag onto the nozzle. The nozzle is 
tapered. When attaching the dust bag, push it onto the 
nozzle firmly as far as it will go to prevent it from coming 
off during operation. 

Fig.11 

When the dust bag is about half full, remove the dust 
bag from the tool and pull the fastener out. Empty the 
dust bag of its contents, tapping it lightly so as to remove 

particles adhering to the insides which might hamper 
further collection. 

NOTE: 

• 

If you connect a Makita vacuum cleaner to this tool, 
more efficient and cleaner operations can be 
performed. 

Connecting a vacuum cleaner 

Fig.12 
For tool without nozzle 

When you wish to perform clean planing operation, 
connect a Makita vacuum cleaner to your tool. Then 
connect a hose of the vacuum cleaner to the nozzle 
(optional accessory) as shown in the figures. 

For tool with nozzle 

When you wish to perform clean planing operation, 
connect a Makita vacuum cleaner to your tool. Then