Bosch AHS 45 15 LI - Инструкция по эксплуатации - Страница 17

 English | 

17

Bosch Power Tools

F 016 L81 269 | (23.9.15)

Continuous Lighting of the Red Battery Charge In-
dicator 

Continuous lighting

 of the 

red

 battery 

charge indicator  indicates that the temper-
ature of the battery is not within the allowa-
ble charging temperature range, see sec-

tion “Technical Data”. As soon as the allowable charging 
temperature range is reached, the battery charger automati-
cally switches to rapid charging.

Flashing Red Battery Charge Indicator 

A 

flashing

red

 battery charge indicator  in-

dicates a different malfunction of the charg-
ing procedure, see section “Troubleshoot-
ing”.

AL 1115 CV

Flashing Battery Charge Indicator 

The charging procedure is signalled by a 

flashing

 battery charge indicator .

Continuous Lighting of the Battery Charge 
Indicator 

Continuous lighting

 of the battery 

charge indicator  indicates that the 
battery is fully charged 

or

 that the 

temperature of the battery is not with-

in the allowable charging temperature range, and cannot be 
charged for this reason. The battery is charged as soon as the 
allowable charging temperature range is reached.

When the battery is not inserted, 

continuous lighting

 of the 

battery charge indicator  indicates that the mains plug is in-
serted in the socket and that the battery charger is ready for 
operation.

Charging Advice

With continuous or several repetitive charging cycles without 
interruption, the charger can warm up. This is not meaningful 
and does not indicate a technical defect of the battery charg-
er.

A significantly reduced working period after charging indi-
cates that the battery is used and must be replaced.

Working Advice



Hold the garden product away from yourself. Stand in a 
secure and stable position.



When storing the product, do no store it hanging on the 
front handle or switch.

Anti Blocking

If the blade stalls on a tough material, the load of the motor in-
creases. The intelligent micro-electronics senses this over-
load condition and repeatedly reverses the motor, in order to 
prevent stalling and to cut the material through.
This audible reversing cut action continues for up to 3 s.
After cutting through, the garden product continues in its nor-
mal mode, or in case the overload condition continues the 
blades automatically stop in the open position (e. g. in case a 
piece of metal fence accidentally blocks the garden product).

Troubleshooting

Problem

Possible Cause

Corrective Action

Hedgecutter does not op-
erate

Battery discharged

Recharge battery; also see “Battery Charging”

Safety switch not activated correctly

see “Mounting and Operation” for correct use

Hedgecutter operates in-
termittently

Internal wiring of machine damaged

Contact Service Agent

On/Off switch defective

Contact Service Agent

Motor reverses repeatedly then stops after 3 s. see “Working Advice” (Anti Blocking)

Motor runs but blades re-
main stationary

Internal fault

Contact Service Agent

Cutting blade hot

Cutting blade blunt

Have blade sharpened

Cutting blade has dents

Have blade inspected/overhauled

Too much friction, due to lack of lubricant

Apply lubricant spray (1 609 200 399) 

Blade will not move

Battery discharged

Recharge battery; also see “Battery Charging”

Machine defective

Contact Service Agent

OBJ_BUCH-1685-004.book  Page 17  Wednesday, September 23, 2015  10:57 AM