Bosch AHS 45 15 LI 0600849 A 00 - Инструкция по эксплуатации - Страница 15

 English | 

15

Bosch Power Tools

F 016 L70 876 | (3.2.14)

This audible reversing cut action continues for up to 3 s.
After cutting through, the garden product continues in its nor-
mal mode, or in case the overload condition continues the 
blades automatically stop in the open position (e. g. in case a 
piece of metal fence accidentally blocks the garden product).

Troubleshooting

Problem

Possible Cause

Corrective Action

Hedgecutter does not op-
erate

Battery discharged

Recharge battery; also see “Battery Charging”

Safety switch not activated correctly

see “Mounting and Operation” for correct use

Hedgecutter operates in-
termittently

Internal wiring of garden product damaged

Contact Service Agent

On/Off switch defective

Contact Service Agent

Motor reverses repeatedly then stalls after 3 s. see “Working Advice” (Anti Blocking)

Motor runs but blades re-
main stationary

Internal fault

Contact Service Agent

Cutting blade hot

Cutting blade blunt

Have blade sharpened

Cutting blade has dents

Have blade inspected/overhauled

Too much friction, due to lack of lubricant

Apply lubricant spray (1 609 200 399) 

Blade will not move

Battery discharged

Recharge battery; also see “Battery Charging”

Garden product defective

Contact Service Agent

Excessive vibra-
tions/noise

Garden product defective

Contact Service Agent

Cutting time per battery 
charge too low

Too much friction, due to lack of lubricant

Apply lubricant spray

Blade needs cleaning

Clean blade

Battery not fully charged

Recharge battery; also see “Battery Charging”

Continuous lighting of the 
battery charge indicator 

No charging procedure 
possible

Battery not (properly) inserted

Properly insert battery into battery charger

Battery contacts contaminated

Clean the battery contacts (e. g. by inserting 
and removing the battery several times) or re-
place the battery

Battery pack defective

Replace the battery

The blades are running 
slow or the anti blocking 
feature is not functioning

Battery discharged

Recharge battery; also see “Battery Charging”

Battery stored outside of battery temperature

Allow battery to warm naturally to room tem-
perature (within battery operating temperature 
0 – 45 ° C)

Battery charge indicator 

does not light up

Mains plug of battery charger not plugged in 
(properly)

Insert mains plug (fully) into the socket outlet

Socket outlet, mains cable or battery charger 
defective

Check the mains voltage; have the battery 
charger checked by an authorised after-sales 
service agent for Bosch power tools

OBJ_BUCH-1685-002.book  Page 15  Monday, February 3, 2014  2:54 PM