Электробритвы Saturn ST-HC7396 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
4
4.
The shaver can run for ten
days after a full charge.
Cleaning & maintenance
To ensure a better shaving effect, the
shaver must be cleaned regularly.
The easiest and most sanitary way to
clean the product is to wash the
shaver head part and the whisker
storeroom with water each time after
using it.
Do be careful while using hot water.
Do remember to check the water is
not too hot to avoid harming hands.
Every day: the shaver head part and
the hair storeroom.
1.
Cut off the power supply of
the shaver, then unplug the charger
and also pull out the product's plug
from the shaver.
2.
Open
the
shaver
head
part(Fig 8).
3.
Clean the shaver head part
and the hair storeroom with hot
running water(Fig 9).
Make sure both of the shaver head
part and the hair storeroom be
cleaned thoroughly.
4.
Wash the product's surface
(Fig 10).
5.
Close the shaver head part
and throw off surplus water.
Do not wipe the shaver head part with
a towel or paper tissues, which may
cause damages to the shaver head.
6.
Open the shaver head part
again and remain so to dry up the
product (Fig 11).
You can also use the brush included to
clean the hair storeroom.
Here water should not be used.
Change
Change the shaver head once a year
to get the best shaving effect. The
shaver has a long service life if not
damaged for human factors.
The damaged or abraded shaver head
can only be replaced with products
SPEED-XL shaver head.
1.
Pull out the old shaver head
assembly out of the shaver (Fig14).
2.
Insert the flange of the new
shaver head assembly into the groove
(1) on the shaver top and then press
down the shaver head assembly (2) to
mount it on the shaver (a click will be
heard) (Fig15).
Specifications
Power:
3 W
Voltage:
220-240 V
Rated current: 0.01 A
Frequency:
50 Hz
Set
Shaver
1
Charger
1
Brush
1
Instruction manual
With warranty book
1
Package
1
Environment friendly disposal
You can help protect the
environment!
Please
remember to respect the
local regulations: hand in
the
non-working
electrical equipment to
an appropriate waste
disposal center.
The manufacturer reserves the
right to change the specification
and design of goods.
