Remington PR1855 - Инструкция по эксплуатации - Страница 6

6

ENGLISH

• 

Caution: After use with shaving gel, please rinse the head and cutters under warm 

water to clean away any excess gel and debris.

STUBBLE LOOK

Fit the stubble head guard to your shaver for a 3-day stubble look.

CARE FOR YOUR SHAVER

Care for your appliance to ensure a long lasting performance. We recommend you clean 

your product after each use. The easiest and most hygienic way to clean the appliance is by 

rinsing the appliance head after use with warm water.

CLEANING CAUTIONS

• 

Ensure the appliance is switched off and unplugged from the mains before cleaning.

• 

Open the shaver head by pressing the release button on the front of the shaver (Fig. A).

• 

Locate the centre arrow and slide the carrier away from the arrow to release  (Fig. C) 

and toward the arrow to snap back in place (Fig. G).

• 

Pull the inner cutter carrier away from the inner cutters (Fig. D).

• 

Thoroughly brush hairs from the inner  and outer cutters. Rinse out remaining debris 

(Fig. E).

• 

Place the inner cutter carrier back into position and lock into place (Fig. F-G).

• 

Align the spring hinge into the slot at the back of the hair pocket and press into place. 

Snap the head assembly closed.

• 

Please note this product is suitable for use in the bath or shower. 

• 

Caution: Keep the adaptor and cable dry.

CLEANING TRIMMER

• 

Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.

REMOVING THE RECHARGEABLE BATTERY 

We strongly recommend that a professional removes the rechargeable battery. Parts of the 

shaver case, and tools have sharp edges and may cause injury if not handled correctly.

• 

The rechargeable battery must be removed from the appliance before it is scrapped.

• 

Disconnect the charging adapter before removing the battery.

1.  Run the shaver until the motor stops.

2.  Unplug the shaver.

3.  Using a small screwdriver, pry the front cover from the shaver (Fig. H).

4.  Remove the rear cover (Fig. I).

5.  Remove the 4 screws located on the front of the shaver (Fig. J).

6.  Pry the battery carrier and circuit board from the shaver body then cut the wires (Fig. 

K-L).