Philips SC1991/00 - Инструкция по эксплуатации - Страница 21

Models SC1992 and SC1991

Operating conditions

Temperature: +15° to +35°C
Relative humidity: 30% to 95%

Storage conditions

Temperature: -20°C to +70°C
Relative humidity: 5% to 95%

Spectrum of body attachment

>500nm

Troubleshooting 

This chapter summarises the most common problems you could 

encounter with the appliance. If you are unable to solve the problem with 

the information below, visit 

www.philips.com/support

 for a list of 

frequently asked questions or contact the Consumer Care Centre in your 

countr y. 

Problem

Possible cause

Solution

The adapter/

appliance becomes 

warm during 

charging.

This is normal.

No action required.

I have switched on 

the appliance but I 

cannot increase or 

decrease the light 

intensity.

The appliance 

has to be reset.

To reset the appliance, switch off the appliance and 

then switch it on again. If you still cannot adjust the light 

intensity, contact the Consumer Care Centre in your countr y, 

your Philips dealer or a Philips ser vice centre.

 The ‘ready to flash’ 

light does not 

work when I place 

the appliance on 

the skin.

You have not 

properly placed 

the appliance on 

the skin.

Place the appliance at a 90° angle onto the skin in such a way 

that all 4 sides of the integrated safety system touch the skin. 

Then check if the ‘ready to flash’ light lights up continuously 

and press the flash button.

If this does not work, place the appliance on a par t of 

your body where it is easy to establish full skin contact, for 

example on your lower arm.Then check if the ‘ready to 

flash’ light works. If the ‘ready to flash’ light still does not star t 

flashing when you place the appliance on the skin, contact the 

Consumer Care Centre in your countr y, your Philips dealer 

or a Philips ser vice centre.

The ‘ready  to 

flash’ light does 

not work when 

I place the body 

attachment on 

my skin, but the 

cooling fan works.

The overheat 

protection has 

been activated.

When the overheat protection has been activated, the fan 

still works. Do not switch off the appliance and let it cool 

down for approx. 15 minutes before you continue to use it. 

After 5 minutes the appliance switches off automatically. Then 

let it cool down for 10 more minutes. If the ‘ready to flash’ 

light still does not work when you place the appliance on 

the skin, contact the Consumer Care Centre in your countr y, 

your Philips dealer or a Philips ser vice centre.

ENGLISH

21