Philips HP6523/02 - Инструкция по эксплуатации - Страница 10

 -

Shave your bikini line as shown in the figure. 

Move the appliance in 

different directions. 

 -

Shave your underarms as shown in the figure. Move the appliance in 

different directions. 

 7 

 When you have finished shaving, switch off the appliance and clean 

the shaving head (see chapter ‘Cleaning and maintenance’). 

Overheat protection

This function helps to prevent overheating of the appliance.

Note: To avoid overheating of the epilator, do not press the appliance too 

hard onto your skin. The epilator works best when you move it over your skin 

without exerting any pressure.

If the overheat protection is activated, the appliance switches off 

automatically and the charging light flashes red for 30 seconds.

To reset the overheat protection, let the appliance cool down and then 

switch it on again.

Note: If the charging light starts to flash red again, the appliance has not yet 

cooled down completely. 

Overload protection

If you press the epilating head too hard onto your skin or when the 

epilating discs of the epilating head get blocked (e.g. by clothes etc.), the 

appliance switches off and the charging light flashes red for 5 seconds.

Turn the epilating discs with your thumb until you can remove whatever is 

blocking the epilating discs. 

Cleaning and maintenance

Never use scouring pads, abrasive cleaning agents or aggressive liquids 

such as petrol or acetone to clean the appliance.
Always keep the adapter dry. Never rinse it under the tap or immerse it 

in water.

Note: Make sure the appliance is switched off and unplugged before you start 

to clean it. 

 -

If necessar y, clean the adapter with the cleaning brush or a dr y cloth. 

 -

After each wet use, clean the appliance thoroughly with water to 

ensure optimum performance. 

ENGLISH

10