Braun PocketGo 555 - Инструкция по эксплуатации - Страница 2

3

English

Batteries

Two 1.5 volt batteries. 
For best performance, use alkaline 
manganese batteries (type LR 6, AM 3, MN 
1500 or size AA alkaline, e. g. Duracell

®

). 

These batteries provide a shaving capacity 
of approx. 60 minutes.
To open the battery cover (6), turn it 90° as 
shown in (c). Insert batteries with the poles 
in the direction marked. Before closing the 
battery compartment, make sure the cover 
is dry and clean.

Note: Never leave batteries in the shaver 
for long periods of time when the shaver is 
not in use (danger of leakage). Take empty 
batteries out of the shaver immediately.

To protect the environment, dispose 
of empty batteries at your retail store 
or at appropriate collection sites 
according to national or local regulations.

This appliance is suitable for use 
in a bath or shower. When using it 
in a shower, we recommend that 

you apply shaving foam or gel. 

Shaving

Turn the twisting protective cap (4) (a) until 
it clicks in place as shown (b). To switch the 
shaver on, push the on/off switch (3) up.

Long hair trimmer 

(575 and 570 models only)
Use the extendable long hair trimmer (5) for 
exact trimming of side burns and mous-
taches. To operate, slide the long hair 
trimmer to the right (e) and turn on the 
appliance. After use, slide it back until it 
engages.

Cleaning and maintenance

For optimum shaving performance, clean 
the shaver after each use:

Cleaning under running water
Turn on the shaver and hold the shaver 
head under warm running water (f). You 
may also use liquid soap. Rinse off all foam 
and let the shaver run for a few more 
seconds. Then turn it off and remove the 
shaver foil (1) as shown (g) and let it dry.
If regularly cleaning the shaver under tap 
water, weekly apply a drop of light machine 
oil onto the long hair trimmer and shaver 
foil. 

Cleaning with the brush
Remove the shaver foil (1) and tap it gently 
against a flat surface. Then thoroughly 
clean the cutter block (2) with the brush (7) 
as shown in (i). Do not clean the shaver foil 
with the brush as this may damage it. 

After cleaning, turn the twisting protective 
cap (4) 180° to cover the shaving head.
In this position, the on/off switch is 
automatically locked to avoid accidental 
operation of the shaver (e. g. when 
travelling).