Braun LS 5300 - Инструкция по эксплуатации - Страница 9

9

When you are finished

After shaving, you may want to smooth 
on a little body cream or lotion. However, 
avoid using irritating substances like deo-
dorants with alcohol right away.

Cleaning

This appliance is suitable for 
cleaning under an open water 
tap.
Warning: Detach the hand-held 

part from the power supply before 
cleaning it in water.
Regular cleaning ensures better shaving 
performance. After each shave, proceed 
as follows (D1):  
• Press the release buttons   to remove 

the shaver head. 

• Rinse the shaver head and the cutter 

block separately under warm running 
water. A natural based soap may 
also be used provided it contains no 
particles or abrasive substances. Rinse 
off all foam.  

• Leave the cutter block and shaver head 

to dry separately.

Alternatively, you may clean the shaver 
using the brush provided (D2): 
• Press the release buttons   to remove 

the shaver head. Tap the bottom of the 
shaver head gently on a flat surface (not 
on the foil). 

• Brush out the cutter block and the 

inside of the shaver head. However, do 
not clean the shaver foil with the brush 
as this may damage the foil. 

Keeping your Braun Silk&Soft 
in top shape

• The shaving parts need to be lubricated 

regularly every 3 months (E). If you 
clean the shaver head under running 

water, lubricate it after each cleaning. 
Apply some light machine oil or vase-
line to the shaver foil and the metal 
parts of the long hair trimmer. Then 
remove the shaver head and also apply 
a tiny amount of vaseline as shown in 
picture section (E).

• The shaver foil and the cutter block 

are precision parts that wear out with 
time. To maintain optimum shaving 
performance, replace your foil and 
cutter block when you notice a reduced 
shaving performance. 

• Do not shave with a damaged foil or 

cord. 

• How to replace the shaving parts

Shaver foil: Press the release buttons 

 to remove the shaver head. To 

remove the shaver foil, press the blue 
plastic frame (F). To mount a new one, 
insert it from inside the shaver head.  
Cutter block: To remove the cutter 
block, press and turn it 90° (G1), then 
take it off. To put on a new cutter block, 
press it onto the cutter block holder 
and turn 90° (G2).

Subject to change without notice.

This product conforms to the 
European Directives EMC 
89/336/EEC and Low Voltage 
73/23/EEC.

Please do not dispose of the 
product in the household waste at 
the end of its useful life. Disposal 
can take place at a Braun Service 
Centre or at appropriate collection points 
provided in your country.

Foe electric specifications, see printing on 
the special cord set.

4

4

4