Braun Clean&Charge - Инструкция по эксплуатации - Страница 7

Braun Clean&Charge has been developed 
to automatically clean and charge your 
shaver. It also serves as a storage unit. 
For peak performance of your shaver, clean 
it daily in the Clean&Charge.

During the automated cleaning process, 
the shaver is switched on and off at inter-
vals to obtain best cleaning results. Since 
the specially formulated cleaning fluid also
contains a small amount of oil, the 
cleaning procedure also fulfills the lubri-
cation needs of your shaver.

Important

•

Only use the power supply cord set supplied 
with the shaver.

•

In order to avoid any leakage of the clean-
ing fluid, place the appliance on a flat, 
stable surface. Be careful not to tip, move 
suddenly or transport in any way if a cleaning 
cartridge is installed.

•

Do not place the appliance in a mirror 
cabinet, nor store it over radiators, nor 
place it on polished or laquered surfaces. 
Do not expose to direct sunlight.

•

The appliance contains highly 
flammable liquid. Keep it away 
from sources of ignition. 
No smoking. Keep out of reach of 
children. Do not refill cartridge. Use only 
original Braun refill cartridge.

•

When cleaning the shaver, its protection cap 
should be removed.

A Description

1 Lift button for cartridge exchange
2 Contact bow
3 Release button
4 Operation mode selector
5 «clean» light: 

cleaning process indicator

6 «charge» light:

charging process indicator

7 «cartridge» light:

cartridge replacement indicator

8 Cleaning cartridge 

Technical specifications

•

Power consumption:
3 W when cleaning
7 W when charging

•

Power supply: 100 -240 V 

2

/ 50 or 60 Hz 

(automatic adaptation)

•

Input voltage: 12 V

B  Before using Clean&Charge

Only applies for rechargeable shavers:

For the first charge of the shaver, connect 
the power supply cord set directly to the 
shaver, charge it for 4 hours and shave at 
least once. 
Only then, can the shaver be cleaned or
recharged in the Clean&Charge.

If the rechargeable battery is discharged, 
select the combined «clean + charge» 
program rather than the «clean» program 
alone. 

Installing the cartridge

•

Press the lift button (1) to open the 
housing.

•

Hold the cartridge down on a flat, stable 
surface (e.g. table).

Carefully remove the lid from the cartridge. 
Slide the cartridge into the base as far as it 
will go.

•

Slowly close the housing by pushing it 
down until it locks.

Replacing the cartridge

After having pressed the lift button to 
open the housing, wait for a few seconds 
before removing the used cartridge. 

Before discarding the used cartridge, make 
sure to close the openings using the lid of the 
new cartridge, since the used cartridge will 
contain contaminated cleaning solution.

8