Braun 7546 - Инструкция по эксплуатации - Страница 8

8

English

Our products are designed to meet the highest standards of quality, 
functionality and design. We hope you enjoy your new Braun appliance.

Warning

• Keep the appliance dry.
• Do not wind the cord around the appliance.
• For safety reasons, periodically check the cord for damage and replace 

it if necessary.

Description

Technical specifications

Power supply: 100 – 240 V 

2

 / 50 or 60 Hz (automatic adaptation) 

Wattage: 4

Charging your beard trimmer for cordless operation

• For the first 3 chargings: Connect the trimmer to the mains with the on/

off switch on position «0» and charge it for at least 4 hours. The pilot 
light indicates that the trimmer is connected to the mains. When the 
rechargeable battery is fully charged, the pilot light will noticeably 
weaken. If later on, the pilot light comes on again, this indicates that the 
trimmer is being recharged to maintain its full capacity.

• Once the trimmer is completely charged, use it without the cord until 

discharged.

• Then recharge to full capacity again (subsequent charges will take 

about 1 hour).

• A full charge will give up to 30 minutes of cordless trimming depending 

on your beard. However, the maximum capacity will only be reached 
after several charging/discharging cycles.

1a Small distance comb (trimming 

beard and short hair)

1b Large distance comb (cutting hair)
2 Pivoting twin cutter system

a beard trimmer
b contour trimmer
c release buttons

3 Speed selector

4 On/off switch

with beard length selector

5 Memory switch

(for 6 beard length settings)

6 Pilot light

5601196_EP100_MN  Seite 8  Dienstag, 18. Januar 2005  10:54 10