Электробритвы Braun 375 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Dieses Gerät darf am Ende seiner
Lebensdauer nicht mit dem Haus-
müll entsorgt werden. Die Entsor-
gung kann über den Braun Kun-
dendienst oder lokal verfügbare Rück-
gabe- und Sammelsysteme erfolgen.
English
Warning
Keep the appliance dry.
Batteries
This appliance operates on two 1.5 volt
batteries. For best performance, use
alkaline manganese batteries (type LR
6, AM 3, MN 1500 or size AA alkaline,
e. g. Duracell). These batteries provide
a shaving capacity of approx. 60 minutes.
Slide the battery cover
0
in the direc-
tion indicated by the arrow, then open.
Insert batteries
9
with the poles in the
direction marked. Close the battery
cover and slide it back to start position.
Note: Never leave batteries in the
shaver for long periods of time
when the shaver is not in use
(danger of leakage). Take empty
batteries out of the shaver imme-
diately. To protect the environment,
dispose of empty batteries at your retail
store or at appropriate collection sites
according to national or local regulations.
Shaving
Turn the twisting protective cap
1
(a)
until it clicks in place as shown (b). To
switch the shaver on, push the on/off
switch
2
upward to the «on» position.
Longhair trimmer
Use the pop-out longhair trimmer
6
for exact trimming of side burns and
moustaches (d).
To operate, push up the switch
7
to
setting «trimmer».
Cleaning and maintenance
To experience the best possible shave
you should clean the shaver after each
use:
1. Press foil frame release buttons
5
and remove the foil frame
4
(e).
2. Tap the foil frame gently against a
flat surface, then clean the cutter-
block
3
thoroughly with the brush
8
as shown (f). To remove the
cutterblock twist through 90° and
pull off (g). When replacing it, make
sure both bars snap into position.
3. Place the foil frame over the cutter-
block and gently push down until it
clicks back into position.
After cleaning, turn the twisting
protective cap
1
180° to cover the
shaving head. In this position, the
«on«/»off» switch is automatically
locked to avoid accidental operation of
the shaver (e. g. when travelling).
Subject to change without notice.
