Philips HX6921 Sonicare FlexCare+ - Инструкция по эксплуатации - Страница 13

inter vals during the brushing cycle. See section ‘Brushing modes’ 

in chapter ‘Using the Sonicare’ (Fig. 7).

The Quadpacer feature on this type has been activated. To deactivate or 

reactivate the Quadpacer feature:

 1 

 Place the handle with a brush head attached on the plugged-in charger.

 2 

 Press and hold the mode button for 2 seconds. 

,

You hear 1 beep to indicate the Quadpacer has been deactivated 

or you hear 2 beeps to indicate the Quadpacer has been activated.

Cord wrap on deluxe charger (specific types only)

If your type includes the deluxe charger cover and base, the travel charger 

is pre-installed inside the cover. If you want to shor ten the mains cord, 

you can store excess cord in the cord wrap feature built into the charger 

base. 

 1 

 To separate the charger cover from the charger base, press the two 

grey snap bars on the charger base and pull the white charger cover  

upwards.  (Fig. 9)

 2 

 Wrap excess power cord around the grey charger base as shown 

in the picture. Be sure to wrap the cord on the inside of the two 

snap levers.  (Fig. 10)

 3 

 When you have stored the excess cord, guide the mains cord 

through the small groove in the rear of the grey charger base.  (Fig. 11)

 4 

 To reattach the charger cover, press it down over the charger base 

until it snaps into place.

Tip: For extra convenience during travel, you can remove the travel charger 

and use it without the charger cover and charger base. 

Cord wrap on sanitiser with integrated charger  

(specific types only) 

 - If your type includes the sanitiser, you can store excess cord in the 

cord wrap feature built into the bottom of the sanitiser.  (Fig. 12)

ENGLISH

13