Philips HX6511 Sonicare EasyClean - Инструкция по эксплуатации - Страница 9

 - The batter y charge indicator shows the approximate remaining 

batter y charge (Fig. 3).

 - Solid green light: 50-100%

 - Flashing green light: 5-49% 

 - Flashing green light and 3 beeps after the brushing cycle: less than 5% 

and toothbrush has to be recharged.

Note: To keep the battery fully charged at all times, you may keep your 

Sonicare on the charger when not in use. It takes at least 24 hours to  

fully charge the battery.

Using the appliance

 1 

 Wet the bristles and apply a small amount of toothpaste.

 2 

 Place the toothbrush bristles against the teeth at a slight angle 

towards the gumline (Fig. 4).

 3 

 Press the power on/off button to switch on the Sonicare.

 4 

 Apply light pressure to maximise Sonicare’s effectiveness and let 

the Sonicare toothbrush do the brushing for you. Do not scrub.

 5 

 Gently move the brush head slowly across the teeth in a small back 

and forth motion so the longer bristles reach between your teeth. 

Continue this motion throughout the brushing cycle.

Note: To make sure you brush evenly throughout the mouth, divide your 

mouth into 4 sections using the Quadpacer feature (see chapter ‘Features’).

 6 

 Brush each section for 30 seconds for a total brushing time of 2 

minutes. Start with section 1 (outside top teeth) and then brush 

section 2 (inside top teeth). Continue with section 3 (outside bottom 

teeth) and finally brush section 4 (inside bottom teeth).  (Fig. 5)

 7 

 After you have completed the 2-minute brushing cycle, you can 

spend additional time brushing the chewing surfaces of your teeth 

and areas where staining occurs. You may also brush your tongue, 

with the toothbrush switched on or off, as you prefer (Fig. 6).

ENGLISH

9