Smeg F67-7 - Инструкция по эксплуатации - Страница 14

Extraordinary maintenance 

30 

7.3

Removing the door 

Use the two splines:

open the door, insert the splines 

G

 into the slit of the hinges and push them towards 

the oven. Half-close the door upward to form an angle of approximately 45°, then lift up 
and slide off. For re-assembly, insert the hinges into its groove then let the door rest 
downwards and extract splines

 G

or 

use two pins: 

open the door completely and fit the pins 

H

 into the holes from the inside.  Close the 

door to an angle of about 45°, lift it and remove it from its seat.  To replace, fit the 
hinges into the grooves provided, then lower the door until it comes to rest and extract 
the pins. If the pins are lost, two screwdrivers can also be used. 

7.4

Cleaning the inside of the window on the door 

The internal surfaces of the door glass can be cleaned by disassembling the 
components of the door itself. Proceed as described in paragraph "7.3  Removing the 
door"; loosen the 3 fastening screws and, by means of a screw-driver, lever upwards.  
Once the two door components have been separated, it is possible to carry out the 
cleaning of the internal surfaces of the glass. To reassemble the door, follow these 
instructions in reversed order.