Kuppersberg SD 693 C - Инструкция по эксплуатации - Страница 9

9

ENGLISH

TECHNICAL PASSPORT

Electric oven

Electrical connection

Â

The oven is manufactured to work 

with  a  one-phase  alternating  current 

(230V  1N~50  Hz)  and  is  equipped 

with a 3 x 1,5 mm2 connection lead of 

1.5  mm  length  with  a  plug  including  a 

protection contact.

Â

A 

connection 

socket 

for 

electricity supply should be equipped 

with a protection pin and may not be 

located  above  the  cooker.  After  the 

cooker  is  positioned,  it  is  necessary  to 

make  the  connection  socket  accessible 

to the user.

Â

Before  connecting  the  oven  to 

the socket, check if:

B

the fuse and electricity supply 

are able to withstand the cooker load,

B

the electricity supply is 

equipped  with  an  efficacious  ground 

system which meets the requirements 

of current standards and provisions,

B

the plug is within easy reach.

Important!

If  the  fixed  power  supply  cable 

is  damaged,  it  should  be  replaced  at 

the manufacturer or at an authorized 

servicing outlet, or by a qualified person 

to avoid danger.

O P E RAT I O N

Before using the appliance for

the first time

Â

Remove  packaging,  clean  the 

interior of the oven,

Â

Take  out  and  wash  the  oven 

accessories with warm water and a little 

washing-up liquid,

Â

Turn on the ventilation in the 

room or open a window,

Â

Heat  up  the  oven  (to  a 

temperature of 250°C for approximately 
30  minutes),  remove  any  stains  and 
wipe the interior carefully. (See section: 
Using the control panel)

Important!

To clean the oven chamber use only 

warm water and a small amount of 

washing-up liquid.

Important!

The oven features touch control 

panel and display. To activate each touch 

sensor, touch the glass above the sensor 
(indicated  by  a  pictogram).  An  acoustic 
signal will be heard. (See section: Using 
the control panel).

Touch sensor surfaces must be kept 

clean.

Some models are equipped with a 

backlit oven door handle. For additional 

information on oven accessories 

depending  on  the  model,  please  see 

section Features and components.

Oven  handle  backlight  is  turned  on 

during operation and acts as oven cavity 

residual heat indicator, i.e. it turns off 
when the temperature inside the oven 

cavity  drops  below  50°C. The  backlight 
is  on  above  50°C  and  light  intensity 
reflects  the  temperature,  i.e.  the  higher 

the temperature inside the oven cavity 

the higher the backlight intensity.