De Dietrich DOP7230X - Инструкция по эксплуатации - Страница 17

11

•

4

CARE

PYROLYTIC SELF-CLEANING

This oven is equipped with a pyrolytic
self-cleaning function:
Pyrolysis is a cycle during which the oven
cavity is heated to a very high
temperature in order to eliminate soiling
from splattering and spills.
Before starting pyrolysis cleaning,
remove any large overspills, if any.
Remove the excess grease on the door
using a damp sponge. 
As a safety measure, cleaning only
occurs after the door locks automatically;
it is impossible to unlock the door.

Remove the accessories and
supports from the oven before

beginning pyrolysis cleaning.

PERFORM A SELF-CLEANING
CYCLE

Proposed cycles:

     PyroExpress in 59 minutes.

This specific function uses the heat
built up during a previous cooking cycle
to quickly and automatically clean the
inside of the oven: it cleans a mildly
dirty oven interior in less than an hour.
The electronic oven temperature
monitor determines whether the
residual heat remaining in the oven
interior is sufficient to provide a good
cleaning result. If this is not the case, 

a

90-minute ECO pyrolysis cycle will
automatically begin.

     Pyrolysis 2h00

for more in-depth cleaning of the inside
of the oven.

IMMEDIATE CLEANING (fig. D)

The programmer must only display the
time. It should not be flashing.
Turn the function selector to one of the
self-cleaning functions.
The pyrolysis cycle begins. The time
starts to count down at once.
During pyrolysis, the symbol  is
displayed in the programmer to
indicate that the door is locked.
At the end of the pyrolysis cycle,  0:00
flashes.

When the oven is cool, use a
damp cloth to remove the white

ashes. The oven is clean again and
ready for further cooking
operations

. 

DELAYED CLEANING  (fig. E)

Follow the instructions in the previous
paragraph and then set the end time for
the pyrolysis cycle by pressing . 

The

display flashes. Set the end time with  +
and - . After these steps, the start of
pyrolysis is delayed so that it finishes
at the programmed time. When the
pyrolysis cycle has finished, put the
function selector back to 0.