STELS 51134 - Инструкция по эксплуатации - Страница 12

12

ENG

SAFETY INSTRUCTIONS

The floor jack is high hazard equipment.
To avoid the risk of injuries and damage to property, read these operating instructions completely and familiarize 
yourself thoroughly with the product. 
This jack may be used only for load lifting. Never use this jack for the raised load pulling. Pulling of the jack  
with lifted load is prohibited.
This jack should be used only on smooth, hard and level surface capable of sustaining the load. Use on other 
surface may cause load to drop.
After lifting, the load should be fixed with the help of special props or supports designed to hold the rated load 
weight and reliably keeping it in the lifted position. 
It is prohibited to stay or carry out works under the lifted load held only by the jack. Stay away from moving 
hinged joints of the jack.
Never exceed the maximum rated lifting capacity of the jack. Overload of the jack may result in its failure  
and cause personal injury.
The safety valve is adjusted for safe operation of the item with maximum rated load of 3 tons. It is prohibited  
to change factory settings of the safety valve on your own; it may cause failure of the item and personal injury.
It is permitted to use only the components and adapters recommended for use by the manufacturer.  
It is prohibited to disassemble the jack on your own initiative, as well as make changes into the construction  
of the jack.
All warning labels should always be legible and these operating instructions should be kept intact during the 
whole service life of the jack.
Failure to heed these rules may result in causing personal injury and failure of hydraulic equipment.

BEFORE USE

Test the jack. Close the release valve by turning it with the help of the handle clockwise until it is firmly closed. 
Insert the handle into the pump unit handle sleeve and make sure that it is reliably fixed in the slot. Pump handle 
several times up and down; when this is done, the lifting arm of the jack should start rising. To lower the lifting 
arm, turn the release valve with the help of the handle counterclockwise by no more than three turns, and when 
the lifting arm is lowered completely, close the release valve by turning its handle clockwise as far as it goes.

1

2

3

CAUTION!

Operation of the jack in the wrong position, on the side, in the upside down 

position is not allowed.

HYDRAULIC FLOOR JACK