Zelmer ZCK8023 - Инструкция по эксплуатации - Страница 10

10

PL

EN

Do not pull on the connection cord in order to unplug it or use it as a handle 
Only fill the kettle with water. Milk and instant beverages will burn and damage the appliance. Never 

operate the kettle   without water and do not over fill it; observe the min and max markings. If the kettle is 

too full, the water will boil over!
Do not put the jug on a stove or in a microwave for re-heating of water.
Always place the kettle on a stable, smooth, flat surface; the power cord must not hang loosely off the 

edge of a table (or any other work surface) or touch a heated surface.
Do not use the kettle with the lid open.
Do not remove the lid when the water is boiling.
If the internal electrical elements are flooded with water, make sure the kettle is completely dry before 

plugging in.
Do not move while the kettle is switched on.
Unplug the product immediately from the mains in the event of any breakdown or damage and contact 

an official technical support service. In order to prevent any risk of danger, do not open the device. Only 

qualified technical personnel from the brand´s Official technical support service may carry out repairs or 

procedures on the device. 

Eurogama Sp. z o.o

.

 disclaims all liability for damages that may occur to people, animals or objects, for 

the non-observance of these warnings.

INSTRUCTIONS FOR USE

Before use

Make sure that all the product’s packaging has been removed. 
Before heating water for the first time, we recommend using the kettle twice, in order to clean the 

system. 

Boiling water

Fill the kettle with fresh water through the open lid (press lid release button)
Read the quantity on the water level indicator. Do not fill less than the minimum and maximum marks 

indicated.
Close the lid until it locks and place the kettle on the power base. The buzzer beeps 2 times
The electrical connection will be made automatically as the kettle slides onto the power base.
The blue encircled lamp of temperature button (default temperature: 100

℃

) is flickering,  and the green 

encircled standby lamp is all-time bright when the plug is connected with the power.
Pushing the standby switch 4) to start boiling, and the flickering blue encircled lamp of temperature 
button become to all-time bright, and the green encircled lamp of “standby” button

 turn to red. The 

buzzer beeps 2 times while boiling. 

The blue temperature button indicator light turns off if no operation in 1minutes, the green standby button 

indicator light turns off if no operation in 6 minutes

Select the temperature by pressing the temperature button you want.

Once the temperature is selected, press the standby button

(4) again and the temperature will be 

selected in blue.

When the kettle reaches the selected temperature, the buzzer beeps 2 times

.

The selected temperature button flashes again and the standby button 

remains solid green.