Atlanta ATH-2425 - Инструкция по эксплуатации - Страница 5

5

EN

3-7

RUS

8-1 2

KZ

13-17

INSTRUCTION MANUAL

3.  Fill  the  kettle  with  water  through  the  top  open.  Water  volume  shall  be  not  less 
than 0.2 l , but not more than the volume marked at the scale as «MAX».
4.  Tightly  close  the  top  of  the  kettle  otherwise  the  kettle  won’t  switch  off  when 
boiling. 
5.  Put the kettle on the base plugged in. The design of the kettle makes it possible 
to put it on the base from any side.  
6.  Push ON push button (C) to boil the water. Iillumination will light up then.
7.  Wait till water is boiling. The kettle will switch off automatically. Boiling process 
may be stopped manually at any time by power button (C). In order to make repeated 
boiling, it is necessary to wait a while, till the kettle get cold a little and heat-sensing 
device arrives to home position.   
8.  Don’t  open  the  top  in  the  process  of  boiling  and  immediately  after  in  order  to 
avoid thermal injury.

NOTES

1.  Never fill the kettle with any liquid except water.  
2.  Be money-saving: don’t boil more water than you need. This will reduce power 
consumption and increase the operating life of the kettle.   
3.  Condensate may appear in the kettle in the course of operation.  
4.  Never heat the kettle on gas or electric stove.  
5.  The kettle shall be used only with the base completed with the supply.   
6.  The manufacturer reserves the right to make change in the kettle’s design.  

SAFETY MEASURES

•  The  kettle  operates  from  power  supply;  power  supply  technical  characteristics 
are specified in the manual. 
•  The  kettle  must  be  used  only  upright.  Never  use  it  on  uneven  and  non-heat-
resistant surface.
•  Use a separate socket for the kettle.
•  The device is not intended for use by persons (including children) with reduced
physical, sensory or mental ability or if they have no experience or knowledge, if
they are not under control or not instructed on the use of the instrument the person
responsible for their safety.
•  If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
•  To avoid the danger, if the power cord has been damaged, it should be replaced 
by the manufacturer, its agent or similar qualified person.
•  As surface temperature of the kettle can be over 60°С, do not touch it except for 
a handle and buttons.