Braun MR730 cm - Инструкция по эксплуатации - Страница 9

10

Switch release 

button 

(2)

 pressed 

down

Charging or operation 

conditions

Green

Battery is fully charged

Red/green flashing

Charge sufficient for at 
least one usage

Red

Battery is discharged

Red

Overheating protection 
active (go to Safety 
features 

A

 Overheat 

protection)

Safety features

Switching on the appliance / Switch lock

The appliance has a switch lock. To safely switch it 
on, follow these points:

1  First press the switch release button (2) with your 

thumb and hold. 

2  Then press the On switch (3). During operation, 

you can stop pressing the switch release button.

If the On switch (3) is not pressed within 
5 seconds, the appliance cannot be switched 
on. The pilot light goes off.   
In order to switch the appliance on, start again 
with step 1.   

Overheat protection

When the overheat protection feature is active, 
the appliance turns off and the pilot light shines 
permanently red.

Reason

Trouble shooting

Blade is blocked

1. Remove motor part
2. Remove the food/

blockage

3. Place the motor part 

into the charging unit 
(connected to the mains) 
for at least 1 second

4. Processing can be 

continued

Appliance is 
overheated

Follow points 1.-4.
If the pilot light still shines 
red when switching on the 
appliance, place the motor 
part back into the charging 
unit and let it cool down 
for ca. 1 hour. During this 
time, the pilot light flashes 
green.

•

•

Auto Off

For safety reasons the appliance turns off after 
4 minutes of permanent usage. The appliance can 
be turned directly on again.

Using your handblender 

The handblender is perfectly suited for preparing 
dips, sauces, soups, mayonnaise and baby food as 
well as for mixing drinks and milkshakes.
a) Remove knife protection at the bottom of the 

blender shaft by removing the adhesive tape. 
Insert the motor part (4) into the blender shaft (6) 
until it locks.

b) Introduce the handblender vertically into the 

vessel, keep the switch release (2) pressed down, 
then press the On switch (3).

c) To remove the blender shaft from the motor part, 

press push buttons (5). 

When operating the handblender in hot liquids do 
not immerse the blender shaft into – or remove it 
from the liquid while the appliance is switched on.

Recipe example: 

Mayonnaise 
200–250 ml oil,
1 egg (yolk and white),
1 tbsp. lemon juice or vinegar, 
salt and pepper to taste

Put all ingredients into the beaker according to the 
a.m. order. Introduce the handblender to the base of 
the beaker. After switching on, keep the handblender 
in this position until the oil emulsifies. Then, without 
switching off, slowly move it up and down until the 
mayonnaise is well combined.

Using your chopper attachment 

The chopper is perfectly suited for chopping meat, 
cheese, onions, herbs, garlic, carrots, walnuts, 
hazelnuts, almonds etc. 

N.B.: Do not chop extremely hard food, such as ice 
cubes, nutmeg, coffee beans or grains.

Before chopping ...

pre-cut meat, cheese, onions, garlic, carrots (s. 
table p. 5)
remove stems from herbs, shell nuts,
remove bones, tendons and gristle from meet.

1. Carefully remove the plastic cover from the blade 

(11b). Caution: The blade is very sharp! Always 
hold it by the upper plastic part. Place the blade 
on the centre pin of the chopper bowl (11c). Press 
down the blade until it locks. Always place the 
chopper bowl on the anti-slip base (11d).

•

•
•