Sven MS-350BL - Инструкция по эксплуатации - Страница 21

a

c

e

b

g

f

h
i

j

d

Remote control

a

     : On/O

ff

 button

b

     : Bluetooth activation button 

c

 VOL+/-: volume up/down

d

 AUX: AUX stereo input selection

e

      : sound on/o

ff

f

       : previous track (in the Bluetooth mode)

g

       : next track (in the Bluetooth mode)

h

      : play/pause (in the Bluetooth mode)

i

 TRE.+/-: treble level up/down

j

 BASS+/-: bass level up/down

Notes:

• Before operating the remote control, extract the battery, 

remove the 

fi

lm protecting the battery from discharge 

during transportation, and insert the battery back into the 

remote control. 

• Use the remote control at an angle of no more than 30°, 

no more than 7 meters away.

• Direct the remote control at the IR receiver display on the 

subwoofer.

• If the remote control does not work, check the battery or 

replace the discharged battery with a new one.

• Remove the battery from the remote control if you don’t 

intend to use it for a long time (more than a week).

5. PREPARATION AND OPERATION

Speaker placement

• 

Place the speakers symmetrically to the listener at least one meter away. The subwoofer emits non- 

directional sound, therefore it can be located in any place of the room where it sounds the best.

• 

Place MSS far away from monitors and TV sets, as insigni

fi

cant image distortion in these supersensitive 

devices is possible.

MSS 

с

onnecting and control

MS-350BL speaker system can be connected to virtually any audio devices: MP3/CD players, PCs, 

laptops, etc. (see connection diagram in Fig. 4).

• 

Before making any connections, make sure the MSS is o

ff

 and unplugged. Then connect the sub- 

woofer OUTPUT 

e

 jack to the satellites using the built-in audio cables.

• 

To connect the MSS to a PC, 

МР

3/CD player or a telephone, use the signal cable 

h

 built into the 

subwoofer. Insert the mini-jack of the signal cable (green) into the line-out port of your PC sound 

card or your MP3/CD player, and the mini-jack of the microphone cable (pink) – into the mic input 

port of your sound card, as shown in Fig. 4.

• 

С

onnect the subwoofer to the mains outlet with the power cord 

d

.

• 

Turn on the subwoofer power supply using the ON/OFF switch (

c

, ON position) on the sub- 

woofer rear panel.

Fig. 3. Remote control

ENG

20

2.1 Multimedia Speaker

System with Bluetooth