Sven MS-2070 - Инструкция по эксплуатации - Страница 20

2.1 Multimedia Speaker System 

ENG

20

l

 TUN +/-: manual band scanning (in the Radio mode)

m

 VOL+/-:  volume level control

n

,   : Previous/Next track (in the Player and Bluetooth 

mode); previous/next station (in the Tuner mode);

ON/OFF   backlight (pressed long)

o

, AUTO: Play/Pause (in the Player and Bluetooth mode);

start/stop auto scan (pressed long in the Tuner mode)

p

 0-9: numeric pad (select track number in the Player mode or 

track number FM Radio)

Battery Installation

•

Open the battery compartment on the back of the remote 

control.

•

Insert the included AAA batteries. 

•

 Close the battery compartment. 

Notes:

• Use the RC at an angle no more than 30° at a distance of 

no more than 7 meters.

• Direct the remote control at the LED display on the 

subwoofer.  

• If the remote control does not work, check the batteries 

or replace the discharged batteries with new ones.

• Remove the batteries from the RC if you don’t intend to 

use it for a long time.

5. PREPARATION AND OPERATION

Speaker placement

• 

Place  the  speakers  symmetrically  to  the  listener  at  least 

one  meter  away.  The  subwoofer  emits  non-directional  sound, 

therefore  it  can  be  located  in  any  place  of  the  room  where  it 

sounds the best.

• 

Place MSS far away from monitors and TV sets, as insignificant 

image distortion in these supersensitive devices is possible.

Installation and operation

Fig. 4. Remote

control

MS-2070 speaker system can be connected to virtually any audio devices: МР3 player, PCs, laptops, 

etc. (see connection diagram in Fig. 5).

• 

Before  making  any  connections,  make  sure  the  MSS  is  off  and  unplugged.  Connect  the  right 

speaker  to  the  subwoofer  AUDIO  OUTPUT  R  with  the  built-in  audio  cable  and  the  left  speaker  –  to 

the AUDIO OUTPUT L. 

• 

To  use  satellites  backlight,  connect  the  built-in  cable  of  each  satellite  to  the  connectors  LED1/

LED2 

h

. 

• 

To connect the MSS to a PC, МР3 player, use a 2RCA to mini-jack signal cable (included). Insert 

the RCA jacks of the signal cable into the L and R jacks of the PC AUDIO INPUT 

j

, and the mini-jack 

of the signal cable – into the LINE OUT port of your PC sound card or an audio output of your МР3  

player, as shown in Fig. 5.