Sven MS-1040 - Инструкция по эксплуатации - Страница 20

ENG

19

Operation Manual

MS-1040

• 

Insert the plug of power cord 

j

 on the rear panel of subwoofer into the socket.

•

 Adjust master volume level to its minimum by turning VOLUME control knob 

d

 counterclockwise 

until it stops.

•

 Shift POWER switch 

a

 on the subwoofer front panel, power LED 

b

 will illuminate on the 

subwoofer front panel.

• 

Switch on the audio source and adjust master volume level by turning VOLUME control knob 

d

on the remote control. While turning the knob clockwise, volume level increases, but while turning it 

counterclockwise, it reduces.

• 

Adjust the subwoofer volume level by turning BASS control knob 

h

. While turning the knob 

clockwise, the subwoofer volume level increases, but while turning it counterclockwise, it reduces. 

Notes. If the speaker system has not been used for a long time, please mind to switch off 

POWER 

a

 on the subwoofer rear panel and pull out its plug 

j

 from the socket. 

6. TROUBLESHOOTING

Problem

MSS does not 
turn on.

No sound or there is 

too quiet sound of 

speakers.
Distortion of sound.

Sound is produced by 

one of the channels 

only.
Remote control is not 

working. 

Cause

MSS is not connected to the mains 

outlet.
Power switch is o

ff

.

Volume level is set at minimum value.

Improperly connected audio source. 

Large amplitude of the input signal.

Improperly connected speakers to 

audio source.

Remote control is not connected to 

the subwoofer.

Solution

Check the connection.

Turn on the switch.
Adjust volume control knob.

Connect audio sources correctly.

Turn down source volume

and MSS volume.
Check the connection of speakers.

Check the connection.

If none of the above mentioned solutions solves the problem, please refer to nearest authorized 

service center for consultation by a quali

fi

ed specialist. Never try to repair the device on your 

own.