Акустика Sven MS-100 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
5. PREPARATION AND OPERATION
Speaker placement
•
Place the speakers symmetrically to the listener at least one meter away. The subwoofer emits
non-directional sound, therefore it can be located in any place of the room where it sounds the best.
•
Place MSS far away from monitors and TV sets, as insigni
fi
cant image distortion in these super-
sensitive devices is possible.
Installation and operation
MS-100 Multimedia Speaker System can be connected to virtually any audio source: DVD/CD, PC
sound card, etc. (see Fig. 2).
•
Before making any connections, make sure that the MSS is switched o
ff
. Then connect the audio
cable built into the subwoofer to SUB OUTPUT on the active speaker rear panel (see Fig. 2).
•
Insert the mini-jack (Ø 3.5 mm) of the signal cable built into the active speaker into the LINE OUT
port of the PC sound card or OUTPUT of the
МР
3/CD-player (see diagram above).
•
Insert the mini-jack of the MSS power supply cable (included) to the active speaker 9V – 900mA
port, as shown in Fig. 2, and insert the MSS power supply plug into the mains socket.
Note. To connect the MSS to a CD/DVD player/TV, use the signal cable built into the active
speaker with a mini-jack to 2RCA adapter (not included).
•
Adjust the volume control knob
c
on the active speaker front panel to its minimum.
•
Switch on the MSS with the power switch button
2
a
. The power LED
b
lights up. Then turn on
an audio source and adjust the MSS volume level with the volume control knob
c
. When you turng
the knob clockwise, volume level increases, but when you turn it counterclockwise, it reduces.
•
MS-100 model can be also used as a 2.0 speaker system. The connection diagram, settings and
adjustments are the same, but without connecting the subwoofer.
Note. If the MSS is left unused for a long time, mind to switch off the device by using
2
a
On/ Off switch on the active speaker front panel and unplug it. To improve the sound quality,
use the Line-Out output of your sound card.
Active speaker
Passive speaker
Subwoofer
Fig. 2. Connection diagram
Р
ower
supply
CD
DVD
PC
Player
ENG
15
Operation Manual
MS-100
